Safety 1st Electrical vans parked at a customer home

Electrical 101

What to Know Before Installing a Level 2 EV Charger at Home

A Level 2 charger is the most useful upgrade most EV owners make at home. Here is what to check before you buy one, so the install goes smoothly and the charger runs safely for years.

Fast callback

Tell us what’s going on. We’ll take it from there.

Fill out the form and we’ll call you back to talk through the job and set a time to come out. You’ll get a clear, written estimate before any work begins.

Rather talk now?(470) 686-6863

Get a Free Estimate

Tell us what you need. We’ll call you back to set up a time.

Prefer to talk? Call (470) 686-6863. Read our reviews.

Level 1 vs. Level 2 charging

Every EV comes with a Level 1 cord that plugs into a regular 120-volt outlet. It works, but it is slow, often just a few miles of range per hour. For short commutes that can be enough. For most drivers, it is not.

A Level 2 charger runs on a 240-volt circuit, the same voltage as a dryer or range. It adds range many times faster, so most cars are full by morning. That is why Level 2 is the standard for home charging.

Step 1: Check your electrical panel

This is the step people skip, and it matters most. A Level 2 charger is a long, steady load, often running for hours. Your panel needs:

  • Open space for a new 2-pole breaker
  • Enough capacity for the charger on top of everything else your home uses
  • A panel in good condition, not a brand with known problems

An electrician can do a load calculation to answer this. If capacity is tight, there are options: setting the charger to a lower amperage, adding a load-management device, or a panel upgrade.

Step 2: Choose the right charger output

Chargers are sold by amperage, and higher is not always better. Your car has a maximum rate it can accept, and your panel has limits. Buying a charger bigger than either one wastes money. Call your electrician before you buy, and they can tell you what fits.

Step 3: Hardwired or plug-in

A hardwired charger connects directly to the circuit. It is clean, permanent and can often run at a higher rate. A plug-in charger uses a 240-volt outlet such as a NEMA 14-50. It is easy to take with you if you move. Either is safe when the circuit, breaker and outlet are installed and rated correctly.

Step 4: Pick the location

  • Close to where your charge port sits when you park
  • A reasonable distance from the panel to keep the wire run and cost down
  • Out of the way of doors and walkways, with the cable off the floor
  • Weather-rated equipment if it goes outside

Step 5: Permits and HOAs

Many EV charger installs need an electrical permit and inspection. If you live in a townhome or an HOA community, check whether exterior equipment needs approval before the work starts.

The bottom line

The charger is the easy part. The circuit and panel behind it are what make it safe. Start with a load check and buy the charger after you know what your home can support.

We install Level 2 chargers across north metro Atlanta. See EV charger installation, or call (470) 686-6863.

From our Google reviews

What homeowners say

Safety first recently installed a new service panel, meter base with a external disconnect for my shop, and a generator hookup for outages. From the first phone contact, until the last visit from Raul, the customer service from him and the office staff set a new standard in customer service and professionalism. They…

Scott Newcomb · Google review

Best electrician I have ever dealt with. Very professional and on time. Did an outstanding job. I will definitely use them again and again. Thrse guys are the GOAT! PLEASE TRY THEM OUT. I promise: you will not regret it.

Patricia Doggett · Google review

I highly recommend Safety 1st Electrical Services Inc. They truly came through for me when I needed help and turned a stressful situation into a much better experience. They were professional, knowledgeable, dependable, and took the time to make sure everything was handled properly and safely.After dealing with…

Deborah Owens · Google review

Read more on our customer reviews page or on Google.

Reviews

What our customers say

See all reviews on Google

How it works

Four steps from call to power on

  1. 1

    Reach out

    Call (470) 686-6863 or send the short form. Tell us what’s going on.

  2. 2

    We take a look

    An electrician checks the problem or the project in person and answers your questions.

  3. 3

    Clear estimate

    You get a written price before any work begins. No surprise charges.

  4. 4

    Safe, clean work

    We do the job to code, test it, and walk you through what we did.

Questions

Questions we hear about this

How long does a Level 2 install take?

A typical garage install with a short run from the panel takes a few hours. Panel upgrades add time.

Can I install a Level 2 charger myself?

It involves a new 240-volt circuit at your panel and usually a permit. It is a job for a licensed electrician.

Do I need a new panel for an EV charger?

Not always. A load calculation tells you if your current panel can handle it.

More answers on our electrical FAQ page, or contact our team with your question.

Questions about your home? Call us.

Call (470) 686-6863 or request a free estimate. We serve Peachtree Corners and north metro Atlanta.

Get a Free Estimate